SPDT switches don't seem to work ...
complete
d
dsball
I made a simple R2R ADC, but in simulation, the SPDT switches I'm using as stand-ins for a digital input are behaving oddly. They don't seem correctly linked to their nets.
On successive reloads, R6P1 has shown 5V, 0V, and some value in between for no apparent reason.
I have seen similar behavior with R5 and R7's simulation. I have tried deleting and rewiring all three switches, but it just keeps failing to simulate a correct value for RxP1 in position A (0V) or B(5V).
Currently it is showing the same net as simultaneously 5V and GND, depending on which resistor I look at.
A
Akshen
complete
A
Akshen
in progress
Jharwin
under review
Jharwin
Hi dsball thanks for the report. I looked at your profile to see the project, but it seems it's currently set to private https://www.flux.ai/dsball/supposed-ivory-proton-packs. Do you mind clicking that "Share" button at the top right and set the permission to anyone can view/comment so I can investigate which SPDT switch you were using?
d
dsball
Jharwin: Done
Jharwin
dsball: Apology for the long wait as I am still trying to figure out if Flux do really have correct simulation model for the SPDT because it doesn't seem to behave to properly.