Is copilot able to add terminals to the schematic?
planned
B
Bee
I made three attempts to upload a picture of a footprint with the pins labeled and asked copilot to add terminals to the schematic corresponding to the picture. Each time it incorrectly interpreted the image (first time it thought there was a center pad and that pin 14 was a NC; second time it misread and shifted two pins over to the wrong number; and third time it misread a pin label as GPIO instead of GPI).
In each attempt it stated how one would add terminals, but it wouldn't do it for me. Is this expected behavior?
I also tried the part creation w/ AI import flow but the process ran for a few hours and didn't complete.
c
collinsemasi
planned
Brooks Solveig
In terms of actions in a project, Copilot is currently only able to create connections. We have plans to enable more actions, but we’re still working on those.
Copilot can create components if you start with a datasheet. Find this action under Flux Menu > Import.
Otherwise, Copilot can understand and interpret your project and images you upload.
B
Bee
Brooks Solveig Thanks for clarifying!
Is a STQFN considered close enough to a QFN that the image recognition and datasheet import should work? I tried the import dialog a second time but it was stuck in 'processing' for a few hours.
Jharwin
Bee: Hi, would you mind uploading that pdf to google drive or dropbox and share the link here?
B
Bee
Jharwin yup, it's available here: https://www.mouser.com/datasheet/2/698/REN_SLG46536r118_DST_20230911-3314281.pdf