Air wires don't all show in the PCB view | Voters

Air wires don't all show in the PCB view

qtsohg

Air wires don't all show in the PCB view even though parts are connected on the Schematic. Asked for support in slack and Nico had a quick look. Once he toggled the copper fill visibility and I refreshed the page, most of them appeared, but not all are visible still. He had the same issue.

A week ago

linwu

Hi. Direct me.

qtsohg

It seems to be very sproadic. I did notice that I get an error in the console when the error occurs (Sadly I did not copy it I just realise! Sorry). Enabling and disabling different views seems to reset it. But also not clear Repro . Sorry

collinsemasi

Hi qtsohg
I'm Collins, I usually hang out around here :)
I think I’ve found repro steps that work every time. I’ve noticed that whenever I clone the project, the newly created clone initially doesn’t show any airwires. This can be resolved with a page refresh, but the initial cloned state gives us a reliable starting point for reproducing the issue.
I'm so sorry about this and having to refresh the page every time the bug occurs! We will get an engineer to look into the issue ASAP and you should be getting updates in this ticket.
Cheers <3

qtsohg

Ok. toggling the fill visibility and refreshing the page restores the air wires.

qtsohg

So, reproduced it. Sadly just by moving items about and tabbing between PCB view and Schematic :(

So not 100% sure what was the trigger. Trying to change the fill did not return it yet.